Amateur radio
Wilson Wideband Directional Antenna 700–2700 MHz (50 Ω)
Product description
Compatibility and frequency range
This wideband directional antenna covers the 700–2700 MHz spectrum and is intended to capture 3G and 4G LTE signals across multiple carriers, including AT&T, T‑Mobile, Verizon, Sprint, Straight Talk, U.S. Cellular and others. Note that U.S. regulations restrict amplification of some specific frequencies used by certain networks, which can limit performance on those bands. Despite that, many users experience measurable gains across the supported bands.
Performance and connector
The antenna delivers up to +10.6 dB of gain at its peak frequencies and is marketed to increase received signal power by up to 32× compared with an interior antenna in weak-signal scenarios. It uses a threaded, weatherproof N‑Female connector designed for reliable transfer of RF energy at multi-megahertz radio frequencies. The unit is specified at 50 ohms and should be paired with 50 Ω coax and proper adapters to maintain impedance matching.
Construction and mounting
Built for exterior use, the enclosure and cabling interface are weather-resistant to withstand outdoor exposure. The package includes a tilt-and-swivel mast bracket that fits 1.25- to 2‑inch pipes or masts, allowing you to secure the antenna to eaves, chimneys, masts, or other exterior mounting points. Polarization is vertical; the antenna is directional, so aiming toward the target tower and securing a stable mount are important for consistent performance.
Use cases and installation notes
This antenna is intended to be used as an outside pickup for a cellular router or a signal booster system rather than as a standalone repeater. Typical installations see the antenna mounted outside, fed with low-loss 50 Ω coax to a router or booster indoors (or in a vehicle). For best results, locate the nearest usable tower with a signal mapping app, match impedance with the cabling and device ports, and aim the antenna toward the tower. Because it is wideband, it is convenient for multi-carrier setups but may not outperform antennas tuned to a single frequency band in long-distance situations.
Pros
- Broad 700–2700 MHz coverage for multiple carriers
- Weatherproof N‑Female connector and rugged housing
- Includes tilt-and-swivel bracket for 1.25–2" masts
Cons
- Wideband design sacrifices some peak gain versus tuned antennas
- Requires 50 Ω cabling and proper connectors for best results
- Regulatory limits can restrict boosting certain carrier frequencies
VerdictA robust wideband Yagi-style antenna built for exterior installation and multi-carrier compatibility. It provides modest directional gain (+10.6 dB peak) across a broad 700–2700 MHz range, a weatherproof N‑Female feed, and a tilt-and-swivel mast bracket for 1.25–2" pipe. Works well when paired with a cellular router or booster and high-quality 50 Ω coax; delivers consistent improvements in signal
Reviews
-
Harry 5/5
Simple and effective
Boosted my cell signal significantly.
-
Chris Tremblay 4/5
Missing wing nuts
Haven't installed yet; the instructions mentioned wing nuts but none were included.
-
Jay 5/5
Easy setup, surprisingly effective
Temporary PVC mount to the eave and a short cable to a MOFI4500. Stock antenna topped at ~7.5 Mbps; with this outside antenna tests ranged from 21 to 32 Mbps. Higher placement should yield even more.
-
Andrew 5/5
Stabilized speeds for live streaming
I used two with a Nighthawk M1 on AT&T. Bars increased and upload stabilized to about 8–11 Mbps, eliminating buffering during live streams. Downloads also rose into the 30+ Mbps range.
-
Drjustice 5/5
From 3 Mbps to 70 Mbps amid trees
For my parents in rural Quebec I paired two of these with a MOFI-4500 and aimed them at a tower ~3 km away, obscured by foliage. Speeds jumped from about 3/0.5 Mbps to roughly 70/40 Mbps—night and day difference.
-
Jammer 5/5
Major signal boost at my rural home
Used with a Netgear M1 and AT&T tower ~3 miles away. Mounted on the eave and ran 50 ft of LMR400 to the router. Indoor options did nothing; after installing this outside antenna my speeds and stability improved dramatically.
-
B. Flank 5/5
Solid improvement for household router
Installed in ~30–45 minutes to bring my router back indoors. Signal strength and SNR improved compared with having the router outside. Minor worry: the included mount uses a single u-bolt while the antenna allows two.
-
Western Ranger 5/5
Good reach and responsive support
Swapped an omni on my booster for this directional unit. Support sent an adapter quickly when needed. In mountainous terrain I can reach a tower about 14 miles away; aim carefully for usable LTE and reliable texting.
-
SJ 4/5
Performs well if installed correctly
This is an endpoint antenna, not a repeater. Find tower azimuth with a phone app, use 50 Ω coax and match the router/booster ports. When impedance and placement are correct, it works fine.
-
HALO1 5/5
Pulled signal out of remote wilderness
Paired with a 4G booster on a camper and mounted to a 12' mast in the San Rafael Swell. Where the omni gave nearly nothing, this directional antenna produced four bars of 4G. Throughput stayed modest but the reception was unexpectedly strong. Narrow beam makes aiming quick.
-
M. Walker 3/5
Wideband convenience, limited long-range gain
I ended up shelving it for a targeted Yagi. Wideband convenience is nice, but I measured roughly 8 dBi and needed higher gain for a tower 16 miles away. A frequency-focused antenna gave much better long-range performance.
-
Rdk inc. 5/5
Excellent product
Very happy with the antenna—solid performance and reliable signal gains.
Comments
No comments yet.
Sign in or sign up to comment.