Bluesea 20FT Dryer Vent Cleaning Kit — 7-Piece Lint Brush Set

Reviews

1. J jimjeeper 5/5

   Solid value and easy to use

   Good value, arrived quickly, and performed well for my needs. Simple to assemble and effective on a routine clean. Recommend.

2. J Jim Alexander 5/5

   Avoid reversing the drill

   This thing pushed through a plugged duct and navigated a sharp 90 with no problem. I didn’t use the vacuum adapter but it seems useful. One strong warning: don’t run the drill in reverse while it’s inside the duct or you risk losing the bit or attachments down the line.

3. M Mr A. 5/5

   Also great for pool filter tubes

   I used it with a hand drill to clear algae from above-ground pool filter tubes. With a bit of soapy water the rods and brush cleaned them out extremely well.

4. J jason blais 5/5

   Happy with the outcome

   As advertised — it did the job I needed. I wrapped duct tape around each joint as an extra precaution since this is a DIY-grade tool and pieces can snap if you push too hard or run the drill too fast.

5. B BobbyHead 5/5

   Surprisingly effective and vacuum-ready

   Handled my 22 ft run with a 90 and a couple 45s. The vacuum adapter fit my 2.5-inch shop vac so I could vacuum as I pushed the rods, which minimized mess. Compared to another kit I tried, these rods were stiffer and the brush larger, and they cleaned more thoroughly without folding up in the duct.

6. C Chris Fowers 3/5

   Can clear serious clogs but connectors are fragile

   It hooks to a standard drill and has plenty of shafts for long ducts. The clog-busting head cleared a squirrel-cache clog I didn't expect. Everything packed back into the small box for storage. Downside: the shaft connection points can snap if you have tight corners or push too hard, and reversing can detach pieces inside the duct. Handle connections carefully when adding sections.

7. R Rebecca 5/5

   Edited: Customer support sent replacements

   Initially some poles tightened so much they wouldn’t unscrew after use and I thought the kit was now a single long rod. I contacted support and they sent replacement parts for the stuck sections. Problem fixed — appreciate the response and parts.

8. R Rob 5/5

   Removed a dangerous lint buildup

   It works. Pulled out tons of fluff that posed a fire risk and now the dryer runs much more efficiently and safely.

9. D Doug 5/5

   Good for long runs when used slowly

   I bought the longer model for what I thought was a 27 ft run and ended up with about 30 ft including several elbows. The brush worked through numerous turns — most resistance was at the adjustable elbows near the dryer. It cleared lint even with about 225 degrees of turns in the first few feet. Tip: run the drill in low gear and set the clutch low so the rods don’t get overstressed; steady, slow pressure prevents snapped sections.

10. D dadio 5/5

    Handy for DIY dryer maintenance

    Worked really well — the ducts looked clean and shiny inside afterward. With a cordless drill and a good shop vac you can avoid hiring a pro; this kit gives you the tools they typically use.

11. B Beth Ellen McNamara 4/5

    Does the job if you're patient

    My dryer showed a blocked-vent icon. The line runs through several elbows to outside, so I worked from the exterior. I started with just two rods and ran the drill forward at low speed. It fed in fine, though pulling the setup out was tougher because my drill lacks a tight chuck. If you have a drill with a secure chuck it should perform better.

12. D Debra 1/5

    Bent and ineffective for my use

    This kit didn’t work for me — the shafts bent and stayed bent while trying to feed them through the duct. I followed setup videos and still had no success. Ended up discarding it.